The right AGN II Line Array has the LM10n planars installed.

Next is install the left channel planars.  Then connect the wiring for the monoblock amps.

Quote from: mresseguie on August 23, 2024, 12:22:20 PM

Leo,

I?ll wager you might have higher attendance if you relocate to the greater Portland, Oregon area. If only for a few days?hint hint. I have yet to hear any of your products - most likely due to our being on opposite sides of the country. Just thinking out loud. 

Michael

He has a tour over at the Steve Hoffman Forums for quite awhile. Demo for a week then ship to the next person. A no brainer.

Thanks! I'm checking it out now. 

Leo,

I?ll wager you might have higher attendance if you relocate to the greater Portland, Oregon area. If only for a few days?hint hint. I have yet to hear any of your products - most likely due to our being on opposite sides of the country. Just thinking out loud. 

Michael

I did some looking around on YouTube and was surprised at how good the quality is on some of the videos. I have an IPhone that I use only for music which goes into my preamp with a digital Bluetooth board that feeds my DAC and back into the preamp.
Can?t imagine what a top notch server would sound like. Time to do some shopping😁

The side stiles were removed and sock on the intermittent 1.7 speaker and had the staples pulled, so easy to pull up the sock.

This one has a break in the woofer foil that had a repair that is not holding. The bigger problem is the woofer foil is delaminating in areas and the mylar is wrinkled. This would need a complete rebuild, so putting it aside.

I looked through the sock with a light on the working speaker and see a bit of the same foil delamination problem, but no wrinkles in the mylar. Once I remove the side stiles and staples, will be time to see if some glue cleaning and reapplication will fix the areas of problems.