The Market > Manufacturer News
The Monoliths II speakers with dspNexus 2x8
HAL:
Time to update the original Monoliths speakers to the Monoliths II's.
Replacing the BG NEO10 planars with the new Radian Audio LM10n planar midranges that are in the Magnetar II speakers.
The dspNexus 2x8 system DSP crossover design will be updated to use the LM10n planars with the GR NEO3 planar tweeters.
Time to wire the planars with Analysis Plus Oval 16 cable to the Parasound Z-Amp v3's for testing.
HAL:
Have the two Monoliths II's wired to start testing.
Now to connect the Parasound Z-Amp v3 to use with CLIO for the frequency response measurements.
Nick B:
--- Quote from: HAL on December 31, 2023, 07:01:28 PM ---Have the two Monoliths II's wired to start testing.
Now to connect the Parasound Z-Amp v3 to use with CLIO for the frequency response measurements.
--- End quote ---
👍 👍 !
HAL:
The Monoliths II are setup for some testing of the new Radian Audio LM10n planar as a midrange. The Parasound Z-Amp v3 fits besides the planars for 2' driver cables.
The CLIO system is setup with the calibrated measurement mic at center of tweeter height.
HAL:
First set of measurements are done and DSP crossover for the Monoliths II's has been updated.
Have the dspNexus 2x8 running the new crossover and have signal through the planars.
The Parasound Z-AMP v3 is driving the two planars. Now to setup the 2x12 servo subs integrated with the planars.
Navigation
[0] Message Index
[#] Next page
Go to full version