Self Medicating > General DIY

Fun with old subwoofer drivers and Magnepan LRS speakers

(1/2) > >>

HAL:
A friend sent me one AV123 UFW-12 sub driver awhile back after he made upgrades to his drivers.

It drops in and screws down into one of the modular 1x12 H-Frames, so decided to give it a try.

Got a used pair of Magnepan LRS for use and with the new MagnaRisers AERO stands, the sub works well to add height to the planars for vertical orientation.   Puts the center about ear height for listening.  I can use the dspNexus 2/8 for the sub to LRS crossover to remove LF info from the planars that helps with power handling. 

This is a prototype since I only have the one driver, but I know others exist.  :)

Fun stuff.

Nick B:
Interesting experiment, Rich 👍

HAL:
Nick,
Yes, have something now to try at CAF2024 with a pair of subs for the LRS for sub stands.

These are the GR-Research SW-12-16FR drivers without the servo amp in the modular open baffle H-Frames.  I have EQ'd them to use in the OB H-Frames instead with the dspNexus 2/8. 

The system has a crossover between the LRS and sub.  No time delay needed with the LRS sitting on the sub. 

The new Magna Risers AERO stands on the LRS put them at listening height for vertical speaker orientation.

Rich

Nick B:

--- Quote from: HAL on November 02, 2024, 02:50:42 AM ---Nick,
Yes, have something now to try at CAF2024 with a pair of subs for the LRS for sub stands.

These are the GR-Research SW-12-16FR drivers without the servo amp in the modular open baffle H-Frames.  I have EQ'd them to use in the OB H-Frames instead with the dspNexus 2/8. 

The system has a crossover between the LRS and sub.  No time delay needed with the LRS sitting on the sub. 

The new Magna Risers AERO stands on the LRS put them at listening height for vertical speaker orientation.

Rich

--- End quote ---

Thanks Rich. I have L12 Rythmik subs, but have hardly used them. I'm curious if you can hear a significant difference with servo vs non servo

Nick

HAL:
The servo amps allow the subs to play lower in frequency and lower in distortion with the cone motion feedback system and current amp output.

The problem is that the Rythmik Audio A370 and latest Rythmik Audio HX310 servo amps when it is available only go to 120Hz cutoff.  I need the HX300 200Hz cutoff to work with the LM10n planars, so I need to do something else instead.  Might as well start from scratch with different ideas.

Navigation

[0] Message Index

[#] Next page