The Market > Manufacturer News
The M1 speaker project with ABC switch
HAL:
Built the two relay driver pc boards and wired them to the output connections.
Next is to wire the RPi5 GPIO wiring to the driver pc boards.
The time to test the relay switching.
HAL:
The ABC Switch RPi5 and Relay control boards are now connected.
Time for some relay testing for channel #1 then swap to channel #2. Then onto both.
HAL:
The ABC Switch system is operational.
Now to finish wiring the passive crossovers for the speakers.
HAL:
The M1 speakers ABC Switch System is ready for testing.
This is the original passive crossovers, upgraded component passive crossovers and inputs for the dspNexus 2/8 DSP crossover system.
Now for system connection and listening trials. Need to level match the 3 crossovers. Cable lengths for each channel are 8ft of Belden 1309A 14awg speaker cable without the PVC jacket.
Then, let the games begin! 😮
Nick B:
--- Quote from: HAL on October 11, 2024, 02:47:08 PM ---The M1 speakers ABC Switch System is ready for testing.
This is the original passive crossovers, upgraded component passive crossovers and inputs for the dspNexus 2/8 DSP crossover system.
Now for system connection and listening trials. Need to level match the 3 crossovers. Cable lengths for each channel are 8ft of Belden 1309A 14awg speaker cable without the PVC jacket.
Then, let the games begin! 😮
--- End quote ---
👍 👍 😃
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version