Systemic Development > Amplification and Preamplification
New Toroid Output Transformers
steve:
I see Piltron does not manufacture audio output transformers anymore. I have heard that the weakness
of the OPTs was the small core, thus saturation due to imbalance of output tube plate currents.
I remember seeing the impressive high frequency response of their transformers.
What do you think of the idea of OPTs with much more core material to over come that weakness?
There would probably be some loss of high frequency response, but from 200khz to 150khz or even 100khz,
would that be a problem?
Do you think there would be a market?
cheers
steve
_Scotty_:
It wouldn't hurt to try a bifilar wound toroidal transformer. This might be better
sounding than a conventionally wound transformer.
Scotty
steve:
--- Quote from: _Scotty_ on March 20, 2024, 08:52:02 PM ---It wouldn't hurt to try a bifilar wound toroidal transformer. This might be better
sounding than a conventionally wound transformer.
Scotty
--- End quote ---
True, they are known for their very low leakage reactance/tight coupling. I would want to
make the core larger than other brands for better bass response, along with continued excellent high
frequency response.
Thanks for your input Scotty. Any more thoughts are more than welcome.
steve
_Scotty_:
Don't fill the center of the transformers with epoxy or pot them, mount the transformers old school with bolts through the middle and plates top and bottom.
While we're at it, go all in and make the power transformers secondary windings bifilar wound as well.
A bifilar wound power transformer improves the high frequencies in a solid state
amp and can help save them when they would be otherwise degraded the very large gauge wire
found in the secondary windings of higher VA rated power transformers.
I would think that doing this in a tube amp couldn't hurt and might be worth it.
Hope these ideas are helpful.
Scotty
steve:
--- Quote from: _Scotty_ on March 22, 2024, 11:16:11 AM ---Don't fill the center of the transformers with epoxy or pot them, mount the transformers old school with bolts through the middle and plates top and bottom.
While we're at it, go all in and make the power transformers secondary windings bifilar wound as well.
A bifilar wound power transformer improves the high frequencies in a solid state
amp and can help save them when they would be otherwise degraded the very large gauge wire
found in the secondary windings of higher VA rated power transformers.
I would think that doing this in a tube amp couldn't hurt and might be worth it.
Hope these ideas are helpful.
Scotty
--- End quote ---
No, the center would Not be filled. I also plan on a clear covering so one can see the winding itself.
Haven't thought about a power tranny, but easily doable, but interesting thoughts Scotty. Appreciate such.
Should a power transformer have flexible leads or solid wire lead out? Or ask the customer? The solid wire lead
would eliminate solder connections.
cheers
steve
Navigation
[0] Message Index
[#] Next page
Go to full version